Snapset II Packer

We are Supplier and Exporter of Snapset II Packer. It is a compression set tool necessary only straight set down weight to pack-off. This packer is run over another compression set packer (such as the AS-III Packer) to selectively treat, manufacture or inject in multiple zone completions. This packer is also used to isolate casing hole perforations.

This packer characteristics a large by-pass area to stop swabbing when running and retrieving. Once the packer is set, pressure from above or below acts down on the valve to maintain the seal and prevent upward movement of the tubing.

When it releasing, the valve allows debris to be washed from the upper slips. This packer is equipped with an internal latch to stop setting prematurely when running in the hole. When releasing, the latch re-attaches to allow movement downhole.